Test the New Trapeze Tool (Week 1)

10/25/2018

First, a huge thank you to everyone who's expressed interest and purchased the Toolkit - I very much appreciate the fantastic response to the launch over the last three weeks!

It's a short post this week - I've been developing a Trapeze Hanger tool that sizes and schematically details trapeze hangers. This will likely be the first of three posts while developing this tool.

Questions for you at this point in time:

(1) What other possible standard trapeze materials do you use that could be helpful as part of this tool?
(2) What would you like to see shown in the detail?
(3) If the detail could be easily translated to AutoCAD from this calculator, could it be something helpful for your projects? If so, what would you want shown and identified?

Click here to test and comment on the Trapeze Hanger tool, thanks in advance!

Know someone who might be interested in resources or articles like this? Forward to a friend.

Don't get these articles sent weekly to your inbox? Subscribe here.

Michael F

10/25/2018 03:03:35 pm

Can the calculator include the options to chose single and double strut, in both slotted and un-slotted configuration?

Joe

10/25/2018 03:05:48 pm

Sure - if you have cutsheets of some that you typically use send them to me at jdmeyer@meyerfire.com. That would be good to incorporate.

Mel

10/26/2018 09:55:54 pm

We are always asked what the fitters preverb to use at each end.
That will prevent the trapeze from sliding off the of hanger rings.

JOE

10/27/2018 05:52:19 am

Right - do you get any responses more than others?

I understand some fitters prefer to drill through the trapeze pipe and put a nut and washer on the underside of it.

Comments are closed.

Test the New Trapeze Tool (Week 1)

ALL-ACCESS

SUBSCRIBE

AUTHOR

FILTERS

ARCHIVES